Higher Level Chemistry

Solutions & Volumetric Analysis

15 Steps · all open

Start at Step 1
  1. Step 1OpenConcentration (mol/L, g/L, %)Molar concentration is the amount of solute in moles divided by the volume of the final solution in litres.
  2. Step 2OpenConcentration units and solution statesA percentage concentration is meaningful only when its denominator, total solution mass or final solution volume, is stated correctly.
  3. Step 3Full accessParts per million and dilution evidenceParts per million by mass is the mass of solute per million equal mass units of the whole sample, so 1 ppm is 1 mg of solute per kg.
  4. Step 4Full accessPreparing a standard solutionA standard solution has an accurately known concentration because a precisely weighed primary standard is dissolved and made up exactly to the mark of a volumetric flask.
  5. Step 5Full accessDilution calculationsDilution adds solvent but no solute, so the moles of solute before and after are equal: c₁V₁ = c₂V₂.
  6. Step 6Full accessThe titration technique [practical work]A titration result is only valid if each piece of glassware is rinsed with the right liquid and every reading reflects the volume actually delivered.
  7. Step 7Full accessAcid–base titration calculationsIn an acid–base titration the moles of titrant used, multiplied by the mole ratio from the balanced equation, give the moles of analyte in the aliquot.
  8. Step 8Full accessVinegar and standardisation calculationsA substance of uncertain strength is found by titrating it against a solution whose concentration is known exactly, then correcting for any dilution made before titrating.
  9. Step 9Full accessChoosing the right indicatorAn indicator is suitable only if its whole colour-change range falls within the steep, near-vertical part of the titration curve at equivalence.
  10. Step 10Full accessBack titrationsIn a back titration a known excess of reagent reacts with the sample, the unreacted excess is titrated, and the difference gives the amount that reacted.
  11. Step 11Full accessRedox titrations (permanganate, thiosulfate)In a redox titration the balanced equation fixes how many moles of analyte react with each mole of titrant, so the titrant moles are scaled by that ratio.
  12. Step 12Full accessWater analysis / hardnessHardness is reported as the mass of CaCO₃ that would contain the same moles of Ca²⁺ and Mg²⁺ ions, usually in mg L⁻¹.
  13. Step 13Full accessCation and anion identificationAn ion is identified only when a specific test gives the reference result and other ions that could give the same result have been ruled out.
  14. Step 14Full accessNitrate phosphate and unknown-salt evidenceA positive test supports an ion only when blanks and controls rule out other sources of the same observation.
  15. Step 15Full accessTitration data & error analysis [investigation link]A titre is the difference between final and initial burette readings, and its reliability depends on reading uncertainty and on averaging only concordant results.