Step 6 of 15 · Worked example · TEACH

← Solutions & Volumetric Analysis

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Chemistry · Solutions & Volumetric Analysis · Step 6

Follow the worked example. At each stage, explain why the next step is justified.

Before being filled with NaOH titrant, a burette is rinsed only with deionised water. Explain the effect on the titre and on the calculated concentration of the acid in the flask.

Before being filled with NaOH titrant, a burette is rinsed only with deionised water. Explain the effect on the titre and on the calculated concentration of the acid in the flask.

Read it once, slowly. Then copy it onto your page.
  • What is going on? The burette holds the NaOH titrant: the solution of known concentration that runs into the acid in the flask.
  • The slip: it was rinsed only with deionised water. The last rinse should be with the NaOH itself.
  • What do they want? The effect on the titre: does the volume of NaOH run in go up, down or stay the same, and why?
  • Then the effect on the calculated concentration of the acid: is the answer worked out too high, too low or right?
Céim

Higher Level Chemistry · Solutions & Volumetric Analysis · Step 6 of 15

The titration technique [practical work]

A titration result is only valid if each piece of glassware is rinsed with the right liquid and every reading reflects the volume actually delivered.

Why it matters

Practical questions regularly ask how a procedural fault changes the titre and the calculated concentration, and marks need the direction and the reason.

The worked example

Before being filled with NaOH titrant, a burette is rinsed only with deionised water. Explain the effect on the titre and on the calculated concentration of the acid in the flask.

How the worked example goes

  1. Read

    • What is going on? The burette holds the NaOH titrant: the solution of known concentration that runs into the acid in the flask.
    • The slip: it was rinsed only with deionised water. The last rinse should be with the NaOH itself.
    • What do they want? The effect on the titre: does the volume of NaOH run in go up, down or stay the same, and why?
  2. Understand

    • What does the water do?
    • A water rinse leaves drops of water on the inside walls of the burette.
    • Pour in the NaOH and it mixes with those drops. The NaOH is diluted: fewer moles of NaOH in each mL than the label says.
  3. Reduce

    • The NaOH in the burette is diluted. The titre is… Larger than it should be: Each mL carries fewer moles of NaOH, so more mL must run in to deliver the fixed moles the acid needs.
    • How does the titre feed the answer?
    • The calculation does not know the NaOH was diluted. It uses the stated c with the measured titre.
  4. Solve

    • Write the explanation.
    • An 'explain' answer gives the cause, then each effect in order, with the reason.
    • Water left in the burette dilutes the NaOH, so its actual concentration is less than stated.
  5. Check

    • Does the direction make sense?
    • Diluted titrant means more of it is needed: titre up ✓
    • A bigger titre times the same stated concentration gives more moles: c(acid) up ✓

Common mistakes to avoid

Key terms

titre · analyte · titrant · aliquot