Step 8 of 15 · Worked example · TEACH

← Solutions & Volumetric Analysis

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Chemistry · Solutions & Volumetric Analysis · Step 8

Follow the worked example. At each stage, explain why the next step is justified.

A 25.0 mL aliquot of diluted vinegar needs 20.0 mL of 0.100 mol L⁻¹ NaOH for neutralisation. Ethanoic acid reacts 1 : 1 with NaOH. Find the ethanoic acid concentration of the diluted vinegar.

A 25.0 mL aliquot of diluted vinegar needs 20.0 mL of 0.100 mol L⁻¹ NaOH for neutralisation. Ethanoic acid reacts 1 : 1 with NaOH. Find the ethanoic acid concentration of the diluted vinegar.

Read it once, slowly. Then copy it onto your page.
  • What is going on? A titration. A pipette puts 25.0 mL of vinegar in the flask: the aliquot. The vinegar was diluted first, because shop vinegar is too concentrated to titrate well.
  • What is given? The titre, 20.0 mL, of NaOH whose concentration is known: 0.100 mol L⁻¹.
  • 1 : 1: one ethanoic acid, CH₃COOH, reacts with one NaOH.
  • What do they want? The concentration of the diluted vinegar. Trap: the diluted one, so do not scale back up to the shop vinegar.
Céim

Higher Level Chemistry · Solutions & Volumetric Analysis · Step 8 of 15

Vinegar and standardisation calculations

A substance of uncertain strength is found by titrating it against a solution whose concentration is known exactly, then correcting for any dilution made before titrating.

Why it matters

Vinegar and standardisation questions combine a titration, a mole ratio and a dilution factor, and each step carries marks.

The worked example

A 25.0 mL aliquot of diluted vinegar needs 20.0 mL of 0.100 mol L⁻¹ NaOH for neutralisation. Ethanoic acid reacts 1 : 1 with NaOH. Find the ethanoic acid concentration of the diluted vinegar.

How the worked example goes

  1. Read

    • What is going on? A titration. A pipette puts 25.0 mL of vinegar in the flask: the aliquot. The vinegar was diluted first, because shop vinegar is too concentrated to titrate well.
    • What is given? The titre, 20.0 mL, of NaOH whose concentration is known: 0.100 mol L⁻¹.
    • 1 : 1: one ethanoic acid, CH₃COOH, reacts with one NaOH.
  2. Understand

    • How much NaOH went in?
    • A litre of the NaOH holds 0.100 mol. We used 20.0 mL, which is 0.0200 L: a small fraction of that litre.
    • Number of moles from a solution
  3. Reduce

    • Ethanoic acid is weak. How many moles of it does the NaOH neutralise? Equal moles, 1 : 1: The equation has one CH₃COOH to one NaOH. Weak acids still react fully in a titration, so the ratio holds.
    • Where do I start?
    • With the solution you know both c and V for: the NaOH. Then the 1 : 1 ratio carries the moles to the acid.
  4. Solve

    • Moles, then concentration.
    • n(NaOH) = 0.100 × 0.0200 = 2.00 × 10⁻³ mol
    • n(CH₃COOH) = 2.00 × 10⁻³ mol (1 : 1)
  5. Check

    • Is it right?
    • Moles back: 0.0800 × 0.0250 = 2.00 × 10⁻³ mol, the moles of NaOH used ✓
    • Second route, 1 : 1: c = 0.100 × 20.0 ÷ 25.0 = 0.0800 ✓

Common mistakes to avoid

Key terms

standardisation · primary standard · dilution factor · ethanoic acid