Step 10 of 15 · Worked example · TEACH

← Solutions & Volumetric Analysis

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Chemistry · Solutions & Volumetric Analysis · Step 10

Follow the worked example. At each stage, explain why the next step is justified.

A sample reacts with 0.0600 mol of a monoprotic acid added in excess. The unreacted acid then requires 0.0100 mol of NaOH for 1 : 1 neutralisation. Find the amount of acid consumed by the sample.

A sample reacts with 0.0600 mol of a monoprotic acid added in excess. The unreacted acid then needs 0.0100 mol of NaOH for 1 : 1 neutralisation. Find the amount of acid used by the sample.

Read it once, slowly. Then copy it onto your page.
  • What is going on? 0.0600 mol of acid is poured onto the sample. In excess: more than the sample can use, so some acid is left over.
  • The unreacted acid, the leftover, is then titrated. It takes 0.0100 mol of NaOH, reacting 1 : 1.
  • What do they want? The amount of acid used by the sample, in moles. Trap: not the leftover, and not the total added.
Céim

Higher Level Chemistry · Solutions & Volumetric Analysis · Step 10 of 15

Back titrations

In a back titration a known excess of reagent reacts with the sample, the unreacted excess is titrated, and the difference gives the amount that reacted.

Why it matters

Back titrations are used for insoluble or slow-reacting samples and are examined as a two-stage mole calculation where the subtraction is the key mark.

The worked example

A sample reacts with 0.0600 mol of a monoprotic acid added in excess. The unreacted acid then needs 0.0100 mol of NaOH for 1 : 1 neutralisation. Find the amount of acid used by the sample.

How the worked example goes

  1. Read

    • What is going on? 0.0600 mol of acid is poured onto the sample. In excess: more than the sample can use, so some acid is left over.
    • The unreacted acid, the leftover, is then titrated. It takes 0.0100 mol of NaOH, reacting 1 : 1.
    • What do they want? The amount of acid used by the sample, in moles. Trap: not the leftover, and not the total added.
  2. Understand

    • Where did all the acid go?
    • Follow the 0.0600 mol. Part of it reacts with the sample. The rest is left in the flask.
    • Every mole of acid added ends up in one of two places
  3. Reduce

    • How do you get the acid used by the sample? Added − left over: The acid added splits into used and left over, so used is what remains when the leftover is taken away.
    • Where do I start?
    • With the titration, because it is the measurement: it gives the leftover. Then subtract from the amount added.
  4. Solve

    • Work it out.
    • n(left over) = n(NaOH) = 0.0100 mol
    • n(used) = 0.0600 − 0.0100
  5. Check

    • Is it right?
    • Put it back together: 0.0500 + 0.0100 = 0.0600 mol, the acid added ✓
    • Size: the sample used less than was added, 0.0500 < 0.0600, and the acid was in excess ✓

Common mistakes to avoid

Key terms

back titration · excess reagent · purity · insoluble sample