Ordinary Level Chemistry

Solutions & Volumetric Analysis

14 Steps · all open

Start at Step 1
  1. Step 1OpenConcentration (mol/L, g/L, %)Concentration tells you how many moles of a substance are dissolved in each litre of the finished solution.
  2. Step 2OpenConcentration units and solution statesA percentage concentration compares the amount of solute with the whole solution, not with the solvent alone.
  3. Step 3Full accessPreparing a standard solutionA standard solution is one whose concentration is known accurately because a pure solid was weighed carefully and made up exactly to the mark.
  4. Step 4Full accessDilution calculationsAdding water to a solution makes it weaker but does not change the number of moles of solute, so c₁ × V₁ = c₂ × V₂.
  5. Step 5Full accessThe titration technique [practical work]Each piece of titration equipment must be rinsed with the right liquid, and readings must show only the liquid that really reached the flask.
  6. Step 6Full accessAcid–base titration calculationsIn a titration, the moles of the solution in the burette tell you the moles of the solution in the flask, using the numbers in the balanced equation.
  7. Step 7Full accessVinegar and standardisation calculationsTo find the strength of something like vinegar, you titrate it against a solution of known concentration and then undo any dilution you made first.
  8. Step 8Full accessUsing indicatorsAn indicator shows the end point by changing colour, and it only gives reliable results if it is used exactly as the method says.
  9. Step 9Full accessBack titrationsIn a back titration you add too much of one reagent on purpose, find how much is left over, and subtract to see how much actually reacted.
  10. Step 10Full accessRedox titrations (permanganate, thiosulfate)In a redox titration the balanced equation tells you how many moles of one substance react with each mole of the other, so you scale the moles by that number.
  11. Step 11Full accessWater analysis / hardnessWater hardness is given as the mass of calcium carbonate, CaCO₃, that would hold the same number of moles of calcium or magnesium ions.
  12. Step 12Full accessCation and anion identificationA test identifies an ion when the result matches a known reference test and nothing else in the sample could give the same result.
  13. Step 13Full accessNitrate phosphate and unknown-salt evidenceA positive test shows an ion is present only if a blank or control rules out any other cause of the same result.
  14. Step 14Full accessTitration data & error analysis [investigation link]A titre is the final burette reading minus the first reading, and only titres that agree closely are averaged.