Step 9 of 14 · Worked example · TEACH

← Solutions & Volumetric Analysis

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Ordinary Level · Chemistry · Solutions & Volumetric Analysis · Step 9

Follow the worked example. At each stage, explain why the next step is justified.

0.100 mol of acid is added to a sample. The acid left over needs 0.0350 mol of NaOH to neutralise it (1 : 1). How much acid reacted with the sample?

0.100 mol of acid is added to a sample.

The acid left over needs 0.0350 mol of NaOH to neutralise it (1 : 1).

How much acid reacted with the sample?

Read it once, slowly. Then copy it onto your page.
  • What is going on? 0.100 mol of acid is added to a sample, more than the sample can use up. Some acid reacts with the sample.
  • What is measured? The acid left over is titrated: it needs 0.0350 mol of NaOH, reacting 1 : 1.
  • What do they want? The acid that reacted with the sample, in moles. Not the acid left over.
Céim

Ordinary Level Chemistry · Solutions & Volumetric Analysis · Step 9 of 14

Back titrations

In a back titration you add too much of one reagent on purpose, find how much is left over, and subtract to see how much actually reacted.

Why it matters

Back titrations come up in questions on substances that do not dissolve, and the subtraction step is worth marks.

The worked example

0.100 mol of acid is added to a sample. The acid left over needs 0.0350 mol of NaOH to neutralise it (1 : 1). How much acid reacted with the sample?

How the worked example goes

  1. Read

    • What is going on? 0.100 mol of acid is added to a sample, more than the sample can use up. Some acid reacts with the sample.
    • What is measured? The acid left over is titrated: it needs 0.0350 mol of NaOH, reacting 1 : 1.
    • What do they want? The acid that reacted with the sample, in moles. Not the acid left over.
  2. Understand

    • Where did the acid go?
    • Every bit of the 0.100 mol ends up in one of two places: it reacted with the sample, or it was left over.
    • Acid added = acid reacted + acid left over
  3. Reduce

    • Which calculation gives the acid that reacted with the sample? 0.100 − 0.0350: Take what was left over away from what was added. The difference is what the sample used.
    • Where do I start?
    • Two lines: the left-over acid from the NaOH, then take it away from the acid added.
  4. Solve

    • Work it out.
    • Left over (1 : 1 with NaOH)
    • = 0.0350 mol
  5. Check

    • Is it right, and did I answer it?
    • Add the two parts back: 0.0650 + 0.0350 = 0.100 mol, the acid added ✓
    • Size: the answer is less than 0.100 mol. The sample cannot use more acid than was put in ✓

Common mistakes to avoid

Key terms

back titration · excess · left over · purity