Step 3 of 11 · Worked example · TEACH

← Current Electricity & Circuits

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Ordinary Level · Physics · Current Electricity & Circuits · Step 3

Follow the worked example. At each stage, explain why the next step is justified.

An ohmic resistor has 27 V across it and current 7/30 A through it. Find resistance.

An ohmic resistor has 27 V across it and a current of 7/30 A through it.

Find its resistance.

Read it once, slowly. Then copy it onto your page.
  • What is going on? A resistor has a push of 27 V across it, and a current of 7/30 A flows through it. Volts are the push, amps are the flow.
  • What does this word tell me? Ohmic: it obeys Ohm's law. Its resistance stays the same, as long as its temperature does.
  • What do they want? Its resistance R, in ohms (Ω). Not the power: that is a different question.
Céim

Ordinary Level Physics · Current Electricity & Circuits · Step 3 of 11

Resistance & Ohm’s Law

Trace complete current paths, label measured quantities and identify component behaviour.

Why it matters

Use resistance = v/i.

The worked example

An ohmic resistor has 27 V across it and a current of 7/30 A through it. Find its resistance.

How the worked example goes

  1. Read

    • What is going on? A resistor has a push of 27 V across it, and a current of 7/30 A flows through it. Volts are the push, amps are the flow.
    • What does this word tell me? Ohmic: it obeys Ohm's law. Its resistance stays the same, as long as its temperature does.
    • What do they want? Its resistance R, in ohms (Ω). Not the power: that is a different question.
  2. Understand

    • What does resistance measure?
    • In the picture: the voltmeter across the resistor reads 27 V; the ammeter in the loop reads 7/30 A through it.
    • Resistance is how hard it is to push current through: how many volts it takes for each amp.
  3. Reduce

    • Ohm's law is V = IR. Which line gives R? R = 27 ÷ 7/30: Divide both sides of V = IR by I: R = V ÷ I, volts per amp.
    • Where do I start?
    • Ohm's law holds because the resistor is ohmic. Rearrange it to get R on its own.
  4. Solve

    • Divide volts by amps.
    • To divide by a fraction, flip it and multiply: dividing by 7/30 is the same as multiplying by 30/7.
    • R = 27 ÷ (7)/(30)
  5. Check

    • Is it right?
    • Work back with the exact value: V = IR = (7)/(30) × (810)/(7) = 27 V, the p.d. given ✓
    • Units: V ÷ A = Ω ✓