Step 5 of 11 · Worked example · TEACH

← Current Electricity & Circuits

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Ordinary Level · Physics · Current Electricity & Circuits · Step 5

Follow the worked example. At each stage, explain why the next step is justified.

An ohmic device at constant temperature has current 6 A at 30 V and current 8 A at 40 V. Find resistance from the slope of V against I.

An ohmic device at constant temperature carries 6 A at 30 V and 8 A at 40 V.

Find its resistance from the slope of the graph of V against I.

Read it once, slowly. Then copy it onto your page.
  • What is going on? Two readings of the same device: 6 A at 30 V, then 8 A at 40 V. Amps are current, volts are p.d.
  • What does this phrase tell me? Ohmic, at constant temperature: the resistance stays the same, so the graph will be a straight line.
  • Which way round is the graph? V against I: V goes up the side, I goes along the bottom. Trap: drawing it the other way round.
  • What do they want? Its resistance, in ohms, found from the slope of that graph.
Céim

Ordinary Level Physics · Current Electricity & Circuits · Step 5 of 11

I–V Characteristics

Trace complete current paths, label measured quantities and identify component behaviour.

Why it matters

Use resistance = (v2-v1)/(i2-i1).

The worked example

An ohmic device at constant temperature carries 6 A at 30 V and 8 A at 40 V. Find its resistance from the slope of the graph of V against I.

How the worked example goes

  1. Read

    • What is going on? Two readings of the same device: 6 A at 30 V, then 8 A at 40 V. Amps are current, volts are p.d.
    • What does this phrase tell me? Ohmic, at constant temperature: the resistance stays the same, so the graph will be a straight line.
    • Which way round is the graph? V against I: V goes up the side, I goes along the bottom. Trap: drawing it the other way round.
  2. Understand

    • How do I picture it?
    • Plot the two readings with I across and V up. Ohmic, so the line is straight and goes through (0, 0).
    • Going from the first reading to the second, the current goes up 2 A and the p.d. goes up 10 V.
  3. Reduce

    • V is up the side, I is along the bottom. Which is the slope? (40 − 30) ÷ (8 − 6): Slope is rise over run: the change in V, the side axis, over the change in I, the bottom axis.
    • Where do I start?
    • Use the slope formula with the two points. V goes on top because V is up the side. The exam writes "change in" as Δ.
  4. Solve

    • Rise over run.
    • R = (V₂ − V₁)/(I₂ − I₁)
    • R = (40 − 30)/(8 − 6)
  5. Check

    • Is it right?
    • Each reading alone: 30 ÷ 6 = 5 Ω and 40 ÷ 8 = 5 Ω. Same as the slope ✓
    • That match is what ohmic means: V/I is the same at every point on the line ✓