Step 2 of 8 · Worked example · TEACH

← Temperature, Heat & Thermal Energy

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Physics · Temperature, Heat & Thermal Energy · Step 2

Follow the worked example. At each stage, explain why the next step is justified.

A thermometer property has reading 11 at 0°C and 113 at 100°C. It is assumed linear. A sample gives reading 42. Find its temperature.

A thermometer property reads 11 at 0 °C and 113 at 100 °C. It is assumed linear.

A sample gives a reading of 42. Find its temperature.

Read it once, slowly. Then copy it onto your page.
  • What is fixed? Two calibration points: the property reads 11 at 0 °C and 113 at 100 °C. The exam calls them the fixed points.
  • What does linear mean? Assumed linear: equal steps in reading always mean equal steps in temperature, all the way between the fixed points.
  • What is measured? A reading of 42. Trap: 42 is in the sensor's own units, not degrees. It is not 42 °C.
  • What do they want? Its temperature: the sample's T, in °C.
Céim

Higher Level Physics · Temperature, Heat & Thermal Energy · Step 2 of 8

Thermometric Properties & Temperature Scales

Identify the system, temperature changes, changes of state and all energy transfers.

Why it matters

Use temperature = 100 × (x-a)/(b-a).

The worked example

A thermometer property reads 11 at 0 °C and 113 at 100 °C. It is assumed linear. A sample gives a reading of 42. Find its temperature.

How the worked example goes

  1. Read

    • What is fixed? Two calibration points: the property reads 11 at 0 °C and 113 at 100 °C. The exam calls them the fixed points.
    • What does linear mean? Assumed linear: equal steps in reading always mean equal steps in temperature, all the way between the fixed points.
    • What is measured? A reading of 42. Trap: 42 is in the sensor's own units, not degrees. It is not 42 °C.
  2. Understand

    • How do I picture it?
    • Picture a ruler printed in readings. The 0 °C mark sits at 11, the 100 °C mark at 113. So 100 degrees span 113 − 11 = 102 units.
    • Linear, so each degree is the same step: 102 ÷ 100 = 1.02 units per degree.
  3. Reduce

    • Readings 11 and 113; the sample reads 42. What fraction of the way up is it? 31/102: 42 − 11 = 31 units up, out of 113 − 11 = 102 units in the interval.
    • Where do I start?
    • That fraction of the 100 °C interval is the temperature. In symbols, with R for a reading:
  4. Solve

    • Measure up from 11, then scale to 100.
    • Subtract 11 top and bottom, divide, then multiply by 100 °C. Round only the last line.
    • T = 100 × (42 − 11)/(113 − 11)
  5. Check

    • Is it right?
    • Back to the reading: 1.02 units per degree
    • 1.02 × 30.392… = 31