Step 9 of 10 · Worked example · TEACH

← Magnetism, Motors, Induction & Electricity Supply

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Physics · Magnetism, Motors, Induction & Electricity Supply · Step 9

Follow the worked example. At each stage, explain why the next step is justified.

A coil has 30 turns. Magnetic flux through each turn changes by 1/500 Wb in 1/10 s. Find the magnitude of average induced emf.

A coil has 30 turns. The magnetic flux through each turn changes by 0.002 Wb in 0.1 s.

Find the size of the average induced emf.

Read it once, slowly. Then copy it onto your page.
  • What is going on? A coil of wire with 30 turns: thirty loops, one after another, like a spring.
  • What changes? The flux through each turn changes by 0.002 Wb. Every turn sees that change; it is not shared out between them.
  • How quickly? The change takes 0.1 s, a tenth of a second.
  • What do they want? The size of the average induced emf: the voltage the coil makes, averaged over that 0.1 s. Size only, no direction.
Céim

Higher Level Physics · Magnetism, Motors, Induction & Electricity Supply · Step 9 of 10

Faraday's Law, Lenz's Law & Generators

State the viewing direction and distinguish field, current, motion and changes over time.

Why it matters

Use emf magnitude = n × f/t.

The worked example

A coil has 30 turns. The magnetic flux through each turn changes by 0.002 Wb in 0.1 s. Find the size of the average induced emf.

How the worked example goes

  1. Read

    • What is going on? A coil of wire with 30 turns: thirty loops, one after another, like a spring.
    • What changes? The flux through each turn changes by 0.002 Wb. Every turn sees that change; it is not shared out between them.
    • How quickly? The change takes 0.1 s, a tenth of a second.
  2. Understand

    • Why is there an emf at all?
    • Push a magnet into a coil joined to a meter: the needle flicks. Hold it still inside: nothing. Pull it out: it flicks the other way.
    • So it is the change in flux that makes a voltage, not the flux itself. That voltage is the induced emf, E.
  3. Reduce

    • Which relation gives the size of the emf? E = N ΔΦ/Δt: Each turn gives ΔΦ/Δt, and the N turns add in series.
    • Where do I start?
    • List the three values. All are in SI units, so webers per second come out as volts.
  4. Solve

    • One turn first, then all 30.
    • Find ΔΦ ÷ Δt, then multiply by 30. Dividing by 0.1 is the same as multiplying by 10.
    • E = N(ΔΦ)/(Δt)
  5. Check

    • Is it right?
    • Work back to ΔΦ
    • ΔΦ = (E Δt)/(N) = ((0.6)(0.1))/(30)