Step 8 of 11 · Worked example · TEACH

← Current Electricity & Circuits

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Physics · Current Electricity & Circuits · Step 8

Follow the worked example. At each stage, explain why the next step is justified.

Two resistors 4 Ω and 7 Ω are connected in series to an ideal 14 V source. Find current and explain why both resistors carry it. Derive the series-resistance relation used.

Resistors of 4 Ω and 7 Ω are in series with an ideal 14 V source.

Find the current and explain why both resistors carry it.

Derive the series resistance relation used.

Read it once, slowly. Then copy it onto your page.
  • What is going on? Two resistors, 4 Ω and 7 Ω, in series: one after the other on a single path round the circuit.
  • What drives it? A 14 V source. Ideal means it has no internal resistance, so the full 14 V goes to the resistors.
  • What do they want? Three things: the current, why both resistors carry it, and the series resistance relation, derived.
Céim

Higher Level Physics · Current Electricity & Circuits · Step 8 of 11

Series Circuits

Trace complete current paths, label measured quantities and identify component behaviour.

Why it matters

Use current = v/(a+b).

The worked example

Resistors of 4 Ω and 7 Ω are in series with an ideal 14 V source. Find the current and explain why both resistors carry it. Derive the series resistance relation used.

How the worked example goes

  1. Read

    • What is going on? Two resistors, 4 Ω and 7 Ω, in series: one after the other on a single path round the circuit.
    • What drives it? A 14 V source. Ideal means it has no internal resistance, so the full 14 V goes to the resistors.
    • What do they want? Three things: the current, why both resistors carry it, and the series resistance relation, derived.
  2. Understand

    • How do I picture it?
    • Sketch one loop: the 14 V source, then the 4 Ω, then the 7 Ω, then back to the source. No junctions, no branches.
    • Charge leaves one terminal, goes through the 4 Ω, then the 7 Ω, and returns. There is no other way round.
  3. Reduce

    • The same current goes through 4 Ω then 7 Ω. What total resistance does the source see? 4 + 7 = 11 Ω: Each coulomb must get through both, one after the other, so the oppositions add.
    • Why do series resistances add?
    • The p.d.s add to the supply. Write each with Ohm's law, using the one current I.
  4. Solve

    • Add the resistances, then divide.
    • The total resistance first, then the supply p.d. over it. Trap: 14 ÷ 4 or 14 ÷ 7 uses one resistor only.
    • R = 4 + 7 = 11 Ω
  5. Check

    • Is it right?
    • p.d. across each, exact current 14/11 A
    • V₁ = 4 × 14/11 = 56/11 ≈ 5.09 V