Step 3 of 11 · Worked example · TEACH

← Current Electricity & Circuits

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Physics · Current Electricity & Circuits · Step 3

Follow the worked example. At each stage, explain why the next step is justified.

An ohmic resistor has 15 V across it and current 1/10 A through it. Find resistance.

An ohmic resistor has 15 V across it and a current of 0.1 A through it.

Find its resistance.

Read it once, slowly. Then copy it onto your page.
  • What is going on? A resistor has a push of 15 V across it, and a small current of 0.1 A flows through it.
  • What does this word give me? Ohmic: it obeys Ohm's law. Its resistance stays the same whatever the p.d., at a fixed temperature.
  • What do they want? Its resistance R, in ohms (Ω).
Céim

Higher Level Physics · Current Electricity & Circuits · Step 3 of 11

Resistance & Ohm’s Law

Trace complete current paths, label measured quantities and identify component behaviour.

Why it matters

Use resistance = v/i.

The worked example

An ohmic resistor has 15 V across it and a current of 0.1 A through it. Find its resistance.

How the worked example goes

  1. Read

    • What is going on? A resistor has a push of 15 V across it, and a small current of 0.1 A flows through it.
    • What does this word give me? Ohmic: it obeys Ohm's law. Its resistance stays the same whatever the p.d., at a fixed temperature.
    • What do they want? Its resistance R, in ohms (Ω).
  2. Understand

    • What does resistance measure?
    • In the picture: the voltmeter across the resistor reads 15 V; the ammeter in the loop reads 0.1 A through it.
    • Resistance is how hard the resistor makes it to push current through: how many volts it takes for each amp.
  3. Reduce

    • Ohm's law is V = IR. Which line gives R? R = 15 ÷ 0.1: Divide both sides of V = IR by I: R = V ÷ I, volts per amp.
    • Where do I start?
    • Ohm's law holds because the resistor is ohmic. Rearrange it for R.
  4. Solve

    • Divide volts by amps.
    • Dividing by 0.1 is the same as multiplying by 10, so the answer is ten times 15.
    • R = (V)/(I)
  5. Check

    • Is it right?
    • Work back: V = IR = 0.1 × 150 = 15 V, the p.d. given ✓
    • Units: V ÷ A = Ω ✓