Step 9 of 11 · Worked example · TEACH

← Current Electricity & Circuits

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Physics · Current Electricity & Circuits · Step 9

Follow the worked example. At each stage, explain why the next step is justified.

Two ideal resistors of 4 Ω and 10 Ω are connected in parallel. Find equivalent resistance. Derive the parallel-resistance relation used.

Two ideal resistors of 4 Ω and 10 Ω are connected in parallel.

Find the equivalent resistance. Derive the parallel resistance relation used.

Read it once, slowly. Then copy it onto your page.
  • What is going on? Two resistors, 4 Ω and 10 Ω. Ideal: each keeps exactly its stated resistance.
  • How are they joined? In parallel: side by side, both joined between the same two points. Two paths for the current.
  • What do they want? The equivalent resistance: one resistor that would do the same job as the pair. And derive the parallel resistance relation.
Céim

Higher Level Physics · Current Electricity & Circuits · Step 9 of 11

Parallel Circuits

Trace complete current paths, label measured quantities and identify component behaviour.

Why it matters

Use resistance = a × b/(a+b).

The worked example

Two ideal resistors of 4 Ω and 10 Ω are connected in parallel. Find the equivalent resistance. Derive the parallel resistance relation used.

How the worked example goes

  1. Read

    • What is going on? Two resistors, 4 Ω and 10 Ω. Ideal: each keeps exactly its stated resistance.
    • How are they joined? In parallel: side by side, both joined between the same two points. Two paths for the current.
    • What do they want? The equivalent resistance: one resistor that would do the same job as the pair. And derive the parallel resistance relation.
  2. Understand

    • How do I picture it?
    • Sketch two points, A and B. Join them with the 4 Ω on one branch and the 10 Ω on another.
    • Both branches start at A and end at B, so each has the same p.d. across it.
  3. Reduce

    • The pair must come out less than 4 Ω. Which rule does that? 1/R = 1/4 + 1/10: Currents add, and each current is V/R. Adding the reciprocals is adding the currents per volt.
    • Why add the reciprocals?
    • Start from the currents adding. Write each with Ohm's law, I = V/R, using the same V.
  4. Solve

    • Add the reciprocals.
    • Use a common denominator, 20. Trap: adding tops and bottoms, 2/14, is not how fractions add.
    • (1)/(R) = (1)/(4) + (1)/(10)
  5. Check

    • Is it right?
    • Second route, two resistors: product over sum
    • R = (4 × 10)/(4 + 10) = (40)/(14) = (20)/(7) ≈ 2.86 Ω ✓