Step 11 of 11 · Worked example · TEACH

← Current Electricity & Circuits

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Physics · Current Electricity & Circuits · Step 11

Follow the worked example. At each stage, explain why the next step is justified.

Diagnose this situation and give the appropriate circuit reasoning: An ideal ammeter is connected directly across a power supply.

An ideal ammeter is connected directly across a power supply.

Diagnose the situation and give the circuit reasoning.

Read it once, slowly. Then copy it onto your page.
  • What is the meter? An ideal ammeter: a meter that measures current and, being ideal, has no resistance at all.
  • How is it wired? Directly across a power supply: one lead on each terminal, with nothing else in the loop. No lamp, no resistor.
  • What do they want? Diagnose the situation: say what goes wrong. Then give the circuit reasoning: why, using circuit laws.
Céim

Higher Level Physics · Current Electricity & Circuits · Step 11 of 11

Circuit Modelling, Measurement & Troubleshooting

Trace complete current paths, label measured quantities and identify component behaviour.

Why it matters

Identify open paths, short paths or inappropriate instrument loading.

The worked example

An ideal ammeter is connected directly across a power supply. Diagnose the situation and give the circuit reasoning.

How the worked example goes

  1. Read

    • What is the meter? An ideal ammeter: a meter that measures current and, being ideal, has no resistance at all.
    • How is it wired? Directly across a power supply: one lead on each terminal, with nothing else in the loop. No lamp, no resistor.
    • What do they want? Diagnose the situation: say what goes wrong. Then give the circuit reasoning: why, using circuit laws.
  2. Understand

    • How do I picture it?
    • Sketch the supply. Draw a wire from its positive terminal to the ammeter, and from the ammeter back to the negative terminal.
    • That is the whole circuit: one loop, the supply and the meter. Nothing else is there to oppose the current.
  3. Reduce

    • The loop is the supply plus 0 Ω. The current is… a very large current: With nothing to limit it, the current rises until only the supply's own internal resistance and the leads hold it back.
    • Where do I start?
    • Replace the ammeter by its resistance, 0 Ω. Then apply Ohm's law to the whole loop.
  4. Solve

    • What goes wrong?
    • 1. The ideal ammeter joins the terminals with 0 Ω: a short circuit.
    • 2. In I = V/R, as R goes to 0, I grows without limit in the ideal model.
  5. Check

    • Is it right?
    • Made-up trial again: 12 V supply, 6 Ω lamp, ammeter in series
    • R = 6 + 0 = 6 Ω