Step 6 of 10 · Worked example · TEACH

← Forces & Newtonian Dynamics

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Ordinary Level · Applied Maths · Forces & Newtonian Dynamics · Step 6

Follow the worked example and explain why each modelling and calculation step is valid.

A body on a horizontal surface has normal reaction 200 N and coefficient of static friction 1/5. Find its maximum available static friction.

A body on a horizontal surface has normal reaction 200 N.

The coefficient of static friction is 0.2. Find the maximum static friction.

Read it once, slowly. Then copy it onto your page.
  • What is going on? A body sits on a flat surface. The surface pushes up on it with 200 N: the normal reaction, R.
  • What else is given? μ = 0.2, the coefficient of friction: a number with no unit that says how grippy the surface is.
  • What do they want? The maximum static friction: the most friction the surface can give before the body slides.
Céim

Ordinary Level Applied Maths · Forces & Newtonian Dynamics · Step 6 of 10

Rough Surfaces & Friction

Friction opposes relative sliding or its tendency, with static friction adjusting up to a maximum and kinetic friction acting during sliding.

Why it matters

Distinguishing actual friction from its maximum prevents you from predicting motion when a body can remain at rest.

The worked example

A body on a horizontal surface has normal reaction 200 N. The coefficient of static friction is 0.2. Find the maximum static friction.

How the worked example goes

  1. Read

    • What is going on? A body sits on a flat surface. The surface pushes up on it with 200 N: the normal reaction, R.
    • What else is given? μ = 0.2, the coefficient of friction: a number with no unit that says how grippy the surface is.
    • What do they want? The maximum static friction: the most friction the surface can give before the body slides.
  2. Understand

    • How do I picture it?
    • Draw the body. R = 200 N pushes up; the weight W pulls down. They balance.
    • Try it: pull with 10 N. The body stays put, so friction pulls back with 10 N.
  3. Reduce

    • Which gives the maximum friction Fₘₐₓ? μ × R: Limiting friction is μ times the normal reaction R.
    • Where do I start?
    • Fₘₐₓ = μ R. Both μ and R are given, so one multiplication does it.
  4. Solve

    • Multiply.
    • 0.2 is one fifth, so multiplying by 0.2 is the same as dividing by 5.
    • Fₘₐₓ = μ R
  5. Check

    • Is it right?
    • Back to μ: 40 ÷ 200 = 0.2 ✓
    • The trials fit: 10 N and 25 N pulls are both under 40 N, so the body stayed at rest. ✓