Step 4 of 10 · Worked example · TEACH

← Work, Energy, Elasticity & Circular Motion

0 of 3 done

Work through the example to CHECK to open the problems.

Reach CHECK to open the problems.Higher Level · Applied Maths · Work, Energy, Elasticity & Circular Motion · Step 4

Follow the worked example and explain why each modelling and calculation step is valid.

A body falls from rest through vertical distance 20 m. Ignore drag and use g=10 m/s². Find speed after the fall.

A body falls from rest through a vertical distance of 20 m.

Ignore drag and use g = 10 m/s². Find its speed after the fall.

Read it once, slowly. Then copy it onto your page.
  • What is going on? A body is let go from rest, so its start speed is 0. It drops 20 m straight down.
  • What is fixed? No drag: no air holding it back. g = 10 m/s². The mass is not given.
  • What do they want? Its speed after the fall, in m/s.
Céim

Higher Level Applied Maths · Work, Energy, Elasticity & Circular Motion · Step 4 of 10

Conservation of Mechanical Energy

Mechanical energy K + U remains constant when only conservative forces do work.

Why it matters

In an exam, comparing energy at two positions can find speed without calculating time or the path travelled.

The worked example

A body falls from rest through a vertical distance of 20 m. Ignore drag and use g = 10 m/s². Find its speed after the fall.

How the worked example goes

  1. Read

    • What is going on? A body is let go from rest, so its start speed is 0. It drops 20 m straight down.
    • What is fixed? No drag: no air holding it back. g = 10 m/s². The mass is not given.
    • What do they want? Its speed after the fall, in m/s.
  2. Understand

    • How do I picture it?
    • Two moments: at the top, still; at the bottom, 20 m lower and moving fast. Compare those two states only.
    • At the top it has height energy, m g h, and no motion energy. At the bottom, take the height as zero: all motion energy, ½m v².
  3. Reduce

    • When could you not use "energy lost in height = energy gained in speed"? When drag or friction acts: Drag turns some energy into heat, so the body gains less motion energy than it loses in height.
    • Where do I start?
    • Here drag is ignored, so energy is conserved. Set the energy at the top equal to the energy at the bottom.
  4. Solve

    • Put in the numbers.
    • Work out v² first, then take the square root. Trap: dropping the 2 gives √200 ≈ 14.1, too small.
    • v² = 2(10)(20)
  5. Check

    • Is it right?
    • Second route, constant acceleration, down positive: v² = u² + 2as = 0 + 2(10)(20) = 400, so v = 20 m/s ✓
    • Both trial masses gave v² = 400 ✓